Inhoudsopgave
Advertenties
EN
GENERAL INSTRUCTIONS
Never aim a laser beam at people or animals. Do not stare into the la-
ser beam. The laser is class two and emits a beam of the wavelength
and power specifi ed in the technical data table. Such a beam does
not pose a threat, but aiming it directly at the eyeball may cause eye
damage. Do not try to disassemble the tool yourself, as this could ex-
pose you to laser radiation. Do not modify the tool, especially the la-
ser system. Do not use the tool in an environment where the ambient
temperature exceeds the operating range. Before using the tool, wait
until it reaches the temperature within the operating range, if the tool
is stored in temperature exceeding the operating range. The product
is not resistant to water and dust penetration. Do not immerse the
product in water, do not use in dusty environments. Do not place the
tool with other items in the toolbox. Impacts can damage the distance
meter. Transport the device in the supplied case. Remove the battery
from the device if it will not be used for a longer time. Do not store
the distance meter at temperatures above 50°C, as this can damage
the LCD. Use a soft, clean, slightly damp cloth to clean the tool. The
laser beam must reach its target, then refl ect and return to the tool.
As a result, the measurement conditions are subject to limitations.
Too bright light at the measuring point or too refl ective a surface, e.g.,
glass, can make measurement diffi cult or impossible. In this case,
change the measurement conditions or select the appropriate meas-
urement method.
DEVICE OPERATION
Installing and replacing batteries
Open the battery compartment cover located in the bottom back part
of the device. The cover is secured with a latch. Install Ni-MH batter-
ies or accumulators in the slots. Pay attention to the correct polarity.
Batteries or rechargeable batteries must always be replaced in sets.
In order to ensure the correct and longest possible operation of the
device, it is recommended to use branded alkaline batteries. To ex-
tend the life of batteries or accumulators, the device will turn off the
laser pointer after about 30 seconds and turn off the power after about
3 minutes after any button has been pressed.
Switching the device on and off
When switching on the device, briefl y press the on/measurement button.
To switch off the device, press and hold the off button for approx.
2 seconds. Release the button, once the display has switched off .
Switching off the device deletes the last indication, but does not delete it
from the measurement memory and restores the single measurement.
23
M A N U A L O R I G I N A L
Advertenties
Inhoudsopgave
