Advertenties
Transport
10 TRANSPORT
For transporting the appliance, e.g. from the main
area to the secondary area, proceed as follows:
1. Stop the appliance with
ton.
2. Switch off the appliance with
3. Lift the appliance with both hands on the
housing:
■
Do not touch the cutting blades.
■
The cutting blades must always point
away from the body.
11 STORAGE
11.1 Storing the automatic lawn mower
The appliance must be stored over winter or
when it is to be taken out of service for an ex-
pected duration of longer than 30 days.
1. Fully charge the rechargeable battery (see
chapter 5.1 "Charging the rechargeable bat-
tery (08)", page 50).
2. Thoroughly clean the appliance (see chapter
9.1 "Cleaning", page 55).
3. Store the appliance:
■
upright on all wheels
■
at a dry, lockable location protected from
frost
■
out of the reach of children
11.2 Storing the base station
The base station can, but does not have to be put
into storage. Storage prevents premature ageing,
however, such as fading of the colour or corro-
sion of the charging contacts.
If the base station remains outdoors:
1. Disconnect the power supply from the mains
supply and unplug from the base station.
2. Roll up the cables of the base station.
3. Store the power supply.
4. Grease the charging contacts with contact
grease.
457825_a
or the stop but-
.
When the base station is to be put into
storage:
1. Carry out all work mentioned above.
2. Disconnect the base station from the bound-
ary cable.
3. Remove the base station and remove any
soiling with a broom and a slightly damp
cloth.
4. Store the base station:
■
at a dry, lockable location protected from
frost
■
out of the reach of children
If only the charging pole is stored:
1. Disconnect the power supply from the mains
supply and unplug from the base station.
2. Disconnect the base station from the bound-
ary cable.
3. Remove any soiling with a broom and a
slightly damp cloth.
4. Removing the charging pole:
■
Unscrew both screws of the charging sta-
tion (08/5).
■
Remove the charging station from the
base station by tilting.
■
Undo the plug connection of the cables
from the base station and charging sta-
tion.
■
Close the opening of the base (08/6) with
the included winter cover (08/7).
5. Store the base station:
■
at a dry, lockable location protected from
frost
■
out of the reach of children
11.3 Winter storage of the boundary cable
The boundary cable can remain in the ground
and does not need to be removed.
1. When the base station has been put into stor-
age: Grease the cable ends with contact
grease and wrap with adhesive tape. This
protects the cable ends against corrosion.
57
Advertenties
