Advertenties
Displaying information
7.11 Recalibrating
If the position or length of the boundary cable has
been changed or the appliance no longer finds
the boundary cable, recalibration is necessary.
Reset calibration
1.
or
2. Reset loop calibration data?
3. Carrying out a calibration movement: see
chapter 5.4 "Carrying out an automatic cali-
bration movement", page 51.
7.12 Restoring factory settings
The factory settings of the appliance can be re-
stored, e.g. before selling the appliance.
* Factory reset
1.
or
Appliance reports: Factory reset com-
pleted
8 DISPLAYING INFORMATION
The Information menu is used for displaying
machine data. No settings can be made in this
menu.
1. Call up the main menu with
* Information
2.
or
3. Select the menu item with
cept with
.
Note: The menu items are described in the
following sections.
4. Return to the main menu with
Blades service
Shows in how many operating hours a blade ser-
vice is required. The counter can be reset manu-
ally. Have the blade service carried out by an AL-
KO dealer, technician or service partner.
Reset the counter for blade service:
Confirm
1.
or
Hardware
Shows information on the appliance, such as
type, year of manufacture, operating hours, serial
identification number, number of mowing inserts,
total mowing time, number of charging cycles, to-
tal charging time, length of the loop of the bound-
ary cable.
Software
Shows the firmware version.
457825_a
Program Info
Shows current settings such as the total weekly
mowing time.
Failures
Shows the fault messages that last occurred with
date, time and fault code.
9 MAINTENANCE AND CARE
9.1
.
or
and ac-
Clean the automatic lawn mower
.
Once a week, carry out the following:
1. Switch off the appliance with
2. Wipe off the surface of the housing with a
3. Brush off the underside, mower deck and cut-
4. Check the cutting blade for damage. If neces-
Cleaning the base station
1. Regularly remove grass residues and leaves
CAUTION!
Risk of injury
Sharp-edged and moving appliance
parts can lead to injury.
■
Always wear protective gloves
during maintenance, care and clean-
ing work.
Cleaning
IMPORTANT!
Danger from water
Water in the automatic lawn mower and
in the base station leads to damage on
electrical components.
■
Do not spray the automatic lawn
mower and base station with water.
CAUTION!
Danger of injury due to the cutting
blade
The cutting blades are very sharp and
can cause cutting injuries.
■
Wear protective gloves.
■
Make sure that parts of the body do
not get into the cutting blade.
broom, a brush, a damp cloth or a fine
sponge.
ting blade with a brush.
sary, replace the following: see chapter 9.3
"Replacing the cutting blades", page 56.
or other objects out of the base station.
.
55
Advertenties
