Programming The Activation Time; Making Coffee - WMF BUENO Gebruiksaanwijzing
Verberg thumbnails
Zie ook voor BUENO:
- Gebruiksaanwijzing (57 pagina's) ,
- Gebruiksaanwijzing (64 pagina's)
Inhoudsopgave
Advertenties
Set current time
After plugging the plug into an outlet, the display shows "12:00".
Press the Prog key. The display shows "CLOCK" and the colon of
"12:00" is blinking. You can now set the current time by pressing the
h and min keys. When "CLOCK" disappears from the display, the clock
is running. Confirmation is not required.
Note: The time must be reset after a power failure or after the plug
was disconnected.
Programming the activation time
The automatic activation of the unit independently starts the brewing
process at the desired time. The activation time can be programmed up
to 24 hours in advance.
Press the Prog key twice. The display shows "TIMER" and the colon of
"00:00" is blinking. You can now change the activation time by pres-
sing the h and min keys. When "TIMER" disappears from the display,
the new activation time is programmed.
You can check the activation time at any time by pressing the Prog
key twice.
Note: The activation time must be reprogrammed after a power failure
or after the plug was disconnected.
Making coffee
Fill only cold water into the water tank. The water level display applies
to the amount of fresh water which is needed to brew the desired
number of cups, each containing 125 ml.
Open the lid to add coffee grounds. Put a 1 x 4 paper filter into the
filter, first slightly folding the embossed edge over. The paper filter
must not protrude beyond the edge of the filter and should therefore
be slightly pressed down by hand.
Add the required amount of coffee grounds. Depending on personal
taste, use approx. 5-7 g of moderately finely ground coffee per cup.
The filter may overflow if it is too finely ground.
Automatic activation
To start brewing automatically at the programmed activation time,
press the Prog key three times. The right indicator light lights up blue.
Brewing starts automatically at the programmed activation time. The
right indicator light goes out; the left indicator light lights up blue.
Immediate start
To start brewing coffee immediately, press the Start/Stop key
. The
left indicator light lights up blue, and brewing starts.
You can stop brewing at any time by pressing the blue lit Start/Stop
key
again.
Wait until the coffee has completely run into the pitcher. After the
pitcher is removed, a drip stop valve prevents remaining coffee from
dripping onto the heating plate.
10
Advertenties
Inhoudsopgave
