Advertenties
•
Make sure that the battery and the battery charger
are clean and dry before you put the battery into the
battery charger.
•
Clean the battery terminals with compressed air or
use a soft and dry cloth.
•
Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.
To examine the cutting equipment
WARNING:
turn the safety key to 0, remove the battery
and wait a minimum 5 seconds.
WARNING:
when you do maintenance on the cutting
equipment. The blade is very sharp and cuts
can easily occur.
1. Examine the cutting equipment for damage
or cracks. Always replace a damaged cutting
equipment.
2. Look at the blade to see if it is damaged or blunt.
Note:
It is necessary to balance the blade after it is
sharpened. Let a service center sharpen, replace and
balance the blade. If you hit an obstacle that causes
the product to stop, replace the damaged blade. Let the
service center estimate if the blade can be sharpened or
must be replaced.
To replace the blade
Technical data on page 22 for the correct type
Refer to
of blade.
WARNING:
of wood to prevent injury to fingers when
you replace the blade. The blade can be
moved when the motor is off and fingers
Battery
LED on the battery
The green LED flashes.
18
To prevent accidental start,
Use protective gloves
Lock the blade with a block
Troubleshooting
Cause
The battery voltage is
low.
can become trapped between the blade and
stationary parts.
1. Lock the blade with a block of wood. (Fig. 44)
2. Remove the blade bolt, the washers and the blade.
(Fig. 45)
3. Examine the blade support and blade bolt to see if
there are damages.
4. Examine the motor shaft to make sure that it is not
bent.
5. When you attach the new blade, point the angled
ends of the blade in the direction of the cutting cover.
(Fig. 46)
6. Make sure that the blade is aligned with the center of
the motor shaft.
7. Lock the blade with a piece of wood. Attach the
washers and tighten the bolt with a torque of 23 –
28 Nm. (Fig. 47) (Fig. 45)
8. Pull the blade around by hand and make sure that it
turns freely.
WARNING:
The blade is very sharp and cuts can
easily occur.
9. Start the product to do a test of the blade. If the
blade is not correctly attached, there is vibration in
the product or the cutting result is unsatisfactory.
To do a check of the side discharge
deflector
The side discharge deflector is attached to the side
discharge opening of the product. It decreases the risk
of objects to eject in the direction of the mow position of
the operator.
1. Make sure that the side discharge deflector is not
damaged.
2. Examine the side discharge deflector. Make sure
that you do not see defects, such as cracks or
broken springs that push the door to close.
3. Replace the side discharge deflector or the springs if
they are damaged.
Solution
Charge the battery. Refer to
Use heavy duty gloves.
To charge the battery on page 15 .
2207 - 004 - 03.11.2023
Advertenties
