Advertenties
•
Put on heavy duty gloves when you use the cutting
equipment. The blade is very sharp and cuts can
easily occur.
•
Keep the cutting edges sharp and clean for the best
and safest performance.
•
Let your service agent regularly examine the product
and make necessary adjustments and repairs.
Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
To assemble the handle
Note:
It is recommended that 2 persons do this
procedure.
Note:
Do not remove the product from the box when
you assemble the handle. The box can be used for
support for the handle during the assembly.
1. Lift and rotate the handle. (Fig. 19)
CAUTION:
sure that the cable does not become
damaged when you rotate the handle.
2. Put the handle on top of the product. Tilt the handle
against the box for support of the handle. Refer to
the illustration. (Fig. 20)
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
•
Extended product information.
14
Assembly
Before you assemble the
To prevent accidental start
Be careful and make
Operation
Before you operate the
•
Obey the instructions for how to change accessories.
Only use accessories from the manufacturer.
•
When not in operation, keep the product, battery and
battery charger apart in a dry, indoor and locked
area. Make sure that children and persons that are
not approved cannot get access to the product,
battery or battery charger.
3. Push the screw (A) through the handle (B), the
plastic washer (C) and the handle support bracket
(D). (Fig. 21)
4. Tighten the nut (E) fully.
5. Remove the product from the box.
6. Fold the handle to upright position. (Fig. 22)
7. Set the handle height to the lowest position. Refer to
To adjust the handle on page 14 .
8. Attach the cable to the lower part of the handle with
the cable clip. (Fig. 23)
9. Attach the lower part of the cable to the handle
support bracket with the cable tie. Cut off the
remaining part of the cable tie. (Fig. 24)
Note:
Make sure that the cable is correctly
attached. A cable that is too loose cause damage
to the cable when the grass catcher is installed. (Fig.
25)
To adjust the handle
1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product. (Fig. 26)
3. Set the handle height in one of the 2 available
positions.
4. Move the knobs up in the direction of the handle until
they stop and you hear a click. (Fig. 27)
5. Tighten the knobs fully.
•
Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
To set the product in operation position
1. Make sure that the lower knobs are loose. Refer to
To adjust the handle on page 14 .
2207 - 004 - 03.11.2023
Advertenties
