Inhoudsopgave
Advertenties
Translation of the original instructions
DIAG-STARTIUM 60-12 / 60-24
• Protect the electrical contacts of the battery against short-
circuiting.
Do not leave a charging battery unattended for a long time
Acid projection hazard!
• Wear safety goggles and protective gloves.
• If your eyes or skin come into contact with battery acid, rinse
the affected part of the body with plenty of water and seek
immediate medical assistance.
Connection / disconnection:
• Disconnect the power supply before connecting/disconnecting
the device to/from the battery
• The terminal of the battery that is not connected to the car frame
must be connected first. The other connection must be made on
the car frame, far from the battery and the fuel line. The battery
charger must be connected to the power supply network.
• After the charging process, disconnect the battery charger from
the power supply network and remove the connector from the
car frame and then the connector from the battery, in this order.
Connection:
• This device must be connected to an earthed power supply.
• This equipment is intended for industrial environments (class A)
and not for residential sites where the electric current is supplied
by the public low-voltage power supply network. There may be
potential difficulties in ensuring electromagnetic compatibility on
these sites, because of the conducted interferences, as well as
radiated radioelectrical frequency.
• This product does not comply with IEC 61000-3-12 and is in-
tended to be connected to private low voltage networks which
are connected to public supply network only at the medium and
high voltage level. If connected to a public low-voltage supply
network, it is the responsibility of the installer or user of the
equipment to ensure, by consulting the operator of the electrical
distribution network, that the hardware can be connected.
Maintenance:
• If the power supply cable is damaged, it must be replaced by the
manufacturer, its service agent or an equally qualified person.
• Service should be performed by a qualified person.
• Warning! Always remove the power plug from the wall socket
before carrying out any work on the device.
• If the internal fuse is blown, it must be replaced by the manufacturer,
its after-sales service or an equally qualified person.
EN
13
Advertenties
Inhoudsopgave
