Inhoudsopgave
Advertenties
en
Fault
Temperature display
indicates "E..".
The light does not function.
There is a thick layer of frost
in the freezer compartment.
Bottom of the refrigerator
compartment is wet.
The refrigerating unit
is switching on more
frequently and for longer.
The temperature
in the refrigerator
compartment is too cold.
Appliance is not cooling,
temperature display and light
are lit.
38
Possible cause
Electronics have detected
a fault.
The LED light is defective.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
The condensation channel
or drainage hole are blocked.
Appliance opened
frequently.
The ventilation openings
have been covered.
Freezer compartment door is
open.
Temperature has been set
too low.
The Super function is
switched on.
Showroom mode is
switched on.
Remedial action
Call customer service.
See chapter "Light (LED)" section.
When the appliance is closed and opened,
the light is on again.
Defrosting the freezer compartment (see
chapter Defrosting). Always ensure that the
freezer compartment door is closed properly.
Clean the condensation channel
and the drainage hole. See chapter Cleaning
the appliance. Fig. #
Do not open the appliance unnecessarily.
Remove obstacles.
Close the freezer compartment door.
The freezer compartment door engages
audibly.
Increase the temperature.
Switch off Super function.
Hold down alarm button, Fig "/5, for
10 seconds until an acknowledgement signal
sounds.
After a short time check whether your
appliance is cooling.
Advertenties
Inhoudsopgave
