Advertenties
▶
Observe the national health and safety requirements.
Careful handling and use of batteries
▶
Do not use the battery as a power source for other unspecified appliances.
▶
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶
Do not expose batteries to high temperatures, direct sunlight or fire.
▶
Do not disassemble, squash or incinerate batteries and do not subject them to temperatures over
80°C.
▶
Do not attempt to charge or continue to use damaged batteries.
▶
If the battery is too hot to touch it may be defective. In this case, place the power tool in a non-
flammable location, well away from flammable materials, where it can be kept under observation
and allowed to cool down. Contact Hilti Service after the battery has cooled down.
Description
Overview of the product
Keyless chuck
@
Motor cooling air intake
;
Grip
=
Switch safety lock
%
Control switch (with electronic speed
&
control)
Intended use
The product described is a hand-held cordless drill designed for drilling blind holes in steel using
Hilti TXBT... stepped drill bits which is a prerequisite for driving Hilti XBT threaded studs.
• Use only Hilti lithiumion batteries of the B 22 series with this product.
• Use only Hilti-approved battery chargers to charge these batteries. More information is available
from your Hilti Store or from www.hilti.group
Switch-on interlock
The tool is equipped with a switch safety lock that can be used to lock the control switch, thereby
preventing inadvertent starting.
Switch positions
• If the switch safety lock is positioned longitudinally, i.e. in line with the working direction of the drill,
the control switch is locked (the switch-on interlock is active).
• If the switch safety lock is pointing to the left relative to the working direction of the drill, the control
switch is free to operate (the switch-on interlock is deactivated).
Overload and overheating protection
The power tool is equipped with an electronic system to protect against overloading and overheating.
The power tool switches itself off automatically in the event of overloading or overheating. After
releasing the control switch, the power tool may not restart immediately when the switch is pressed
again (while the power tool is cooling down).
Activation of the automatic cut-out is indicated by all 4 LEDs on the battery display blinking.
Liion battery display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display
on the Liion battery. The charge status of the Liion battery is displayed after pressing one of the
two battery release buttons.
Status
4 LEDs light.
*2127431*
1
2
2127431
Belt hook
(
Battery
)
Air exit
+
Battery release button
§
Battery display
/
Meaning
Charge status: 75 % to 100 %
15
Advertenties
