Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Connection of the alarm and protection signals on the GSM board
Quad-Band GSM 850/900 / 1800/1900 MHz - which operates in 2G
(optional board)
Before inserting the SIM card, proceed as follows:
- DISABLE THE PIN CODE using a mobile phone,
- DISABLE THE ANSWERING MACHINE.
To insert the SIM card in the device is required:
- turn off the control panel and open the cover with caution
- unlock the door of the GSM module pushing it up and lift
it up
- insert the SIM card in the door with its chip facing the
contacts and its diagonal corner in the lower-right position;
- lower the door and push it gently downwards
- close the cover and turn on the control panel.
The sim card is always to be inserted and/or
removed with the system TURNED OFF.
The device works with either prepaid or subscription SIM
cards as well as data SIM cards that operate on 2G.
DL 1 green:
- FIXED ON (4-5 sec.): power-up routine in progress
- FLASHING FAST (1 sec.): GSM network search
- FLASHING SLOW (3 sec.): GSM network attached
NOT USED INPUT
SUPPLY BOARD (230-400Vac)
VISUAL ALARM OUTPUT (12V-30mA)
LED 1 red:
- FIXED ON: gsm not configured
- FLASHING: alarm active
- OFF: OK!
(GSM configured and no active alarm)
LED 2 green:
- FIXED ON: OK!
(software gsm properly functioning)
-OFF: software malfunction
LED 1 (fixed on) + LED 2 (flashing):
update parameters in progress
NOT USED INPUT
MAXIMUM LEVEL ALARM CONTACT
(NO) INPUT IN BLACK-OUT:
it is a further input (in addition to that on
the main board), usually connected to a
float for signaling, by means of sending
of SMS, the alarm of the highest level
active only in case of black-out.
When the power supply is on the input
turns off. It is not necessary any setting,
it is activated automatically when you
enable the GSM card.
43
Advertenties
Inhoudsopgave
