Inhoudsopgave
Advertenties
The setting of all the parameters for the program operating mode DIGIT is complete.
Refer to section "INSTALLATION EXAMPLES" for directions of the connections and the applications of the mode DIGIT.
Similarly of the previous program operating mode, it is possible to select "Program MULTITANK" and set all its
parameters.
To proceed and set all the parameters of the operating mode MULTITANK press the button
With the parameter "Operation Mode Pump 1" it is possible to select one of the following modes
for pump 1:
Program
1=Operating mode CLEAN – EMPTY
MULTITANK
2=Operating mode CLEAN – FILL
3=Operating mode DARK – EMPTY
4=Operating mode DARK – FILL
Operation Mode
5=Operating mode DIGIT – EMPTY
Pump 1 1-6 X
6=Operating mode DIGIT – FILL
The "X" indicates the setting of the parameter to modify.
Factory default setting: 1 (CLEAN – EMPTY).
NOTE: the setting of the alarm level/pressure and commands of the pumps of operating mode
MULTITANK are under the submenu "Enable 4-20 mA" of the menu "General Settings". In addition, it is
necessary to set the parameters "Stop P1" and "Start P1".
To move to the next horizontal parameter press the button
With the parameter "Operation Mode Pump 2" it is possible to select one of the following modes
for pump 1:
1=Operating mode CLEAN – EMPTY
Operation Mode
2=Operating mode CLEAN – FILL
Pump 2 1-4 X
3=Operating mode DARK – EMPTY
4=Operating mode DARK – FILL
The "X" indicates the setting of the parameter to modify.
Factory default setting: 1 (CLEAN – EMPTY).
NOTE: for pump 2 the operating mode DIGIT is not available.
To move to the next horizontal parameter press the button
The parameter "Enable MULTITANK" will enable/disable the operating mode MULTITANK. The
mode MULTITANK recognises the operating settings of the pumps installed.
To enable the operating mode MULTITANK press the button
Enable
will show briefly the message "save" as confirmation that the setting has been saved. In the
MULTITANK
main display the word "mlt" will show to indicate the selected program operating mode.
The setting of all the parameters for the program operating mode MULTITANK is complete.
Refer to section "INSTALLATION EXAMPLES" for directions of the connections and the applications of the mode
MULTITANK.
Similarly of the previous program operating mode, it is possible to select "Program PAUSE/WORK" and set all its
parameters.
32
Operation Mode
Pump 1 1-6 X
Operation Mode
Pump 2 1-4 X
:
Operation Mode
Pump 2 1-4 X
:
Enable
MULTITANK
:
to save its setting. The display
Advertenties
Inhoudsopgave
