Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The parameter "Operating mode Empty/Fill" will set the mode of the program "Clean" to
Program
"empty" or "fill". Typically with "Empty" the start/stop float or pressure switches of the pumps
CLEAN
are inside the tank in which the pump is installed. With "Fill" the start/stop float or pressure
switches are in a different tank from which the pumps are installed.
The "X" indicates the setting of the parameter to modify.
0=EMPTY
Operating mode
Empty/Fill
X
1=FILL
Factory default setting: 0 (Empty).
To move to the next horizontal parameter press the button
The parameter "Enable CLEAN" will enable/disable the program operating mode Clean. Once
enabled the mode CLEAN it will apply to all the installed pumps.
To enable the operating mode Clean press the button
Enable
CLEAN
show briefly the message "save" as confirmation that the setting has been saved. In the main
display the word "cln" will show to indicate the selected program operating mode.
Factory default setting: CLEAN enable.
The setting of all the parameters for the program CLEAN operating mode is complete.
Refer to section "INSTALLATION EXAMPLES" for directions of the connections and the applications of the mode CLEAN.
Similarly of the previous program operating mode, it is possible to select "Program DIGIT" and set all its parameters.
To proceed and set all the parameters of the operating mode DIGIT press the button
The parameter "Operating mode Empty/Fill" will set the mode of the program "Digit" to "empty"
Program
or "fill". Typically with "Empty" the 4-20 mA devices are inside the tank in which the pump is
DIGIT
installed. Typically, with "Fill" the 4-20 mA devices are in a different tank from which the pumps
are installed.
The "X" indicates the setting of the parameter to modify.
Operating mode
0=EMPTY
Empty/Fill
X
1=FILL
Factory default setting: 0 (Empty).
To move to the next horizontal parameter press the button
The parameter "Enable DIGIT" will enable/disable the program operating mode DIGIT. Once
enable the mode DIGIT it will apply to all the installed pumps.
Enable
To enable the operating mode DIGIT press the button
DIGIT
show briefly the message "save" as confirmation that the setting has been saved. In the main
display the word "Dig" will show to indicate the selected program operating mode.
NOTE: the setting of the alarm level/pressure and commands of the pumps of operating mode DIGIT are
under the submenu "Enable 4-20 mA" of the menu "General Settings". The setting of the level/pressure
needs to be consistent with the logical of operating mode selection (empty or fill).
Operating mode
Empty/Fill
X
Operating mode
Empty/Fill
X
:
Enable
CLEAN
to save its setting. The display will
:
Enable
DIGIT
to save its setting. The display will
:
31
Advertenties
Inhoudsopgave
