Advertenties
1.Charge the battery fully before using it for the first time.
2.Push the battery into the product until it engages with an audible click.
3.Check that the battery is seated securely.
Removing the battery
1.Press the battery release button.
2.Remove the battery from the product.
Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶
Use only the Hilti tool tether recommended for your product.
▶
Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap #2293133 and
the Hilti tool tether #2261970.
▶
Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶
Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool
tether.
Changing the saw blade
Removing the saw blade
WARNING
Risk of burns and cut injuries at saw blade, clamping screw and clamping flange The
consequences can be burns and cut injuries.
▶
Wear protective gloves when changing saw blades.
1.Press and hold down the spindle lock button (1).
2.Use the hex key to slacken the clamping screw (2).
3.Remove the clamping screw and the clamping flange (3).
4.Open the pivoting guard (4) and remove the saw blade (5).
If necessary, the mounting flange can be removed for cleaning.
Installing the saw blade
5.Clean the mounting flange and the clamping flange.
6.Slip the mounting flange right way round on to the arbor (1).
7.Open the pivoting guard (2).
8.Insert the new saw blade.
Note the direction-of-rotation arrows (3) on the saw blade and on the product. They must
point in the same direction.
9.Place the outer clamping flange in position, right way round (4).
10. Install the clamping screw.
11. Insert the hex key into the saw blade clamping screw.
12. Press and hold down the spindle lock button (5).
13. Use the hex key to tighten the clamping screw (6).
30
2
3
,
2360040
*2360040*
Advertenties
