Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
PROBLEMS
No water comes out of the
nozzle.
The high-pressure cleaner
stops during operation.
T h e c l e a n e r r e s u m e s
operation spontaneously
when it is in Total Stop
mode.
When the master switch (1)
is turned, the motor hums
but does not start.
CAUSES
No water.
Faulty operation of the
water mains disconnector.
Too much suctioning depth.
Water nozzle clogged.
Tripping of system cutout device to
which the high-pressure cleaner is
connected (fuse, RCCB, etc.).
Tripping of the ampere cut-out
protection device.
Leaking and/or dripping in the
delivery circuit.
Electrical system and/or extension
inadequate.
Make sure the water mains tap is completely
open or the suction hose can prime.
type
See table in relative instruction manual.
BA
Make sure the priming depth is in conformity
with the indications of the paragraph
"OPERATION - PRELIMINARY ACTIVITIES"
. 6 -
FIg
opEratIon
Clean and/or replace the nozzle as indicated
in the
"ROUTINE MAINTENANCE"
Reset the cutout device.
In case this trips again, do not use the
high-pressure cleaner and contact a skilled
technician.
Follow the indications of the
paragraph.
DEVICES"
Check the integrity of the delivery circuit.
Make sure the power line connection
instructions have been followed (see
the
I N S T R U C T I O N M A N UA L - S A F E T Y
PRECAUTIONS
extension used.
REMEDIES
.
M
paragraph.
"SAFETY
), with special reference to the
EN
27
Advertenties
Inhoudsopgave
