Advertenties
Beschikbare talen
Beschikbare talen
ANNEX 2 - UNPAIRING AN RF DEVICE
To unpair an RF device previously paired to the Connect CRP, proceed as follows.
From Connect CRP:
• Access the "TECHNICIAN" menu (see "6.1 Accessing the TECHNICAL menu" on page 111)
• Follow the path
MENU >> TECHNICIAN >> INSTALLATION >> ZONE MANAGEMENT >> (CHOOSE THE DESIRED
ZONE) >> RF DEVICES >> CRX ZONE or VALVE 1
• Press the
button.
• The message "LEAVING RF DEVICE IN PROGRESS..." will appear on the screen
From CONNECT CRX ZONE:
• Press button B on the thermostat for 1-2 sec.
• Wait for the unpairing to finish.
If the operation occurs without problems, a screen with
green background will appear with the message OK.
From C-TRV:
Carry out the reset procedure described in the reference
manual.
The Connect CRP will signal correct pairing via an "OK"
message or "KO" in case of error.
In the latter case, try repeating the operation.
NOTE: If the Connect CRP receives no response from the RF device within one minute, the relevant zone
is automatically unpaired from the RF device.
cod. 3542B390 - Rev 04 - 01/2023
fig. 80
fig. 81 - C-TRV
EN
117
Advertenties
