Download Print deze pagina

Advertenties

Beschikbare talen
  • NL

Beschikbare talen

  • DUTCH, pagina 18
Accessory for venting into the room
1. Remove the pre-punched corner of the cover.
2. Connect the DN40 vent pipe (provided by the customer).
The accessories include a circular activated carbon filter,
which minimises the odour when ventilating into the room.
Maintenance and replacement of the filter takes place from
the outside, via the ventilation grille.
NOTICE! Before inserting a new activated carbon filter, the film
must be removed.
MOUNTING
Prepare the installation area for the system and install the inlet
pipes, the pressure pipe and the vent.
1. Use a hole saw (Ø 56) to open up the connection branches for
the
sanitary
fixtures
Emergency drainage
3. Secure it with a hose clamp (tightening moment: 1.5 Nm).
Make sure that the outlet end of the hose is securely sealed.
Installation in a pre-wall
4. Install the non-return valve between elbow and pressure
pipe.
to
be
drained.
2.
Deburr
the
edges of the hole.
NOTICE! The piece
cut out for the hole
must not be left in the
tank.
For emergency drainage pur-
poses, you can install a
length of garden hose at the
bottom right of the tank to
drain away the water accu-
mulated in the tank.
1.
Drill open the Ø 13 branch
at the bottom of the tank
with a twist drill (maximum
Ø 9).
2. Push the hose onto the
branch.
1. Fix the DN 50 connec-
tion collars onto the in-
let pipes using the hose
clamps.
2. Attach
the
connec-
tion collars to the tank in-
let branches with the hose
clamps.
3. Connect the outlet el-
bow to the pressure outlet
of the unit.
NOTICE! All hose clamp connections must be tightly fitted.

Wall mounting

Wall mounting is possible for both of the long sides of the tank.
1. Screw the two brackets to the wall with a spacing of 172 mm.
Use the drilling template provided on the last page of this
manual.
2. Use the elongated holes to align the unit horizontally.
3. Position the rubber spacer below and midway between the
two brackets and screw it to the wall.
4. Lift the HEBEFIX MINI into place with its slots over the
brackets.
5. Adjust its position slightly if necessary.
ENGLISH
5.
Secure the Hebefix Mini
against buoyancy and to pre-
vent twisting! Screw the unit
firmly to the floor with the
provided fasteners.
11

Advertenties

loading