Inhoudsopgave
Advertenties
Insert the bowl:
–
Tilt the bowl forwards and then set it
down.
–
Turn anti-clockwise until it locks into
place.
Press the Release button and move
the swivel arm to position 3.
Remove drive cover from the drive
of the continuous-feed shredder
(Fig. -5a).
Hold disc holder at the lower end,
ensuring that the two tips are face up.
Carefully place the required slicing or
shredding disc onto the tips of the disc
holder (Fig. -6a). In the case of
reversible discs, ensure that the required
side is face up.
Grip disc holder at the upper end and
insert into the housing (Fig. -6b).
Attach the cover (note mark) and turn all
the way in a clockwise direction.
Place continuous-feed shredder on the
drive and rotate all the way in a clockwise
direction, as illustrated in Fig. -8.
Turn rotary switch to recommended
setting.
Put food to be processed in the feed tube
and push down with the pusher.
Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Note: If the food to be processed sticks in the
continuous-feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove cover
from the continuous-feed shredder and
empty feed tube.
After using the appliance
Switch off the appliance with the rotary
switch.
Rotate the continuous-feed shredder in
an anti-clockwise direction and remove.
Rotate the lid in an anti-clockwise
direction and remove.
Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Fig. ).
Clean parts.
Robert Bosch Hausgeräte GmbH
Blender
Risk of injury from sharp blades/
rotating drive!
Never place fingers in the attached
blender! Do not remove/attach the blender
until the drive is at a standstill! Operate the
assembled blender only and with the lid
attached.
Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid. Add a max.
0,5 litres of hot or frothing liquid.
Warning!
Blender may be damaged. Do not process
deep-frozen ingredients (except ice cubes).
Do not operate blender when empty.
Working with the blender
Press the release button and move
the swivel arm to position 4.
Remove the blender drive cover.
Attach blender jug (mark on the handle on
mark on the base unit) and turn all the
way in an anti-clockwise direction.
Add ingredients.
Maximum amount of liquid = 1.25 litres;
maximum amount of frothing or hot
liquids = 0.5 litres;
Optimal processing capacity – solids =
50–100 g;
Attach the cover and turn anti-clockwise
all the way into the blender handle.
The cover must be locked in position.
Set the rotary switch to the desired
setting.
Adding more ingredients
Switch off the appliance with the rotary
switch.
Remove the lid and add ingredients
or
remove the funnel and gradually add
solid ingredients through the refill
opening
or
pour liquid ingredients through the funnel.
en
Fig.
Fig. -8
9
Advertenties
Hoofdstukken
Inhoudsopgave
