Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Start-up
● Automatic signal detection
After inserting the batteries, you have 20 seconds to set the current air pressure
and the weather display 35 .
28
If you do not set anything, the air pressure and the weather are set automatically.
□
Press the arrow up button 11 or the arrow down button 12 to adjust the air
pressure 28 .
□
Press the HISTORY button 15 to confirm your selection.
□
Press the arrow up button 11 or the arrow down button 12 to adjust the
weather display 35 to the weather at your location.
□
Press the HISTORY button 15 to confirm your selection.
The radio-controlled weather station now automatically tries to detect the radio
signal of the outdoor sensor and the DCF radio signal. This procedure can take
several minutes.
The RF signal icon 55 flashes while the outdoor sensor's signal is being detected
(see Fig. E). The temperature and the air humidity of the outdoor sensor are
displayed 47 49 (see Fig. E). If the synchronisation failed, the RF signal icon 55
goes off.
The DCF signal icon 38 flashes while the DCF radio signal is being detected (see
Fig. D).
Only the SNOOZE/LIGHT button 3 and the arrow down button 12 function
during this time.
Note: You can cancel the signal detection by pressing and holding the arrow
down button 12 until the DCF signal icon 38 goes off.
Once the DCF signal is received, the time 43 , date 40 and weekday 41 are set
automatically. The DCF signal icon 38 goes off.
During daylight saving time, the DST icon 39 is displayed (see Fig. D).
18
GB/IE/NI
Advertenties
Hoofdstukken
Inhoudsopgave
