Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ADVICE FOR SAFE INSTALLATION
☺
Put the detector:
outside the house, in a place sheltered from extremes of weather,
G
parallel to the wall,
G
2.20 metres above ground level.
G
Do not install the detector
facing a source of intense light (e.g. bright sunlight, car headlights),
G
facing or above a shiny surface or surface that may heat up quickly,
G
facing a plate glass window,
G
directly on to a metal surface,
G
behind an obstacle (e.g. a pillar or wall) that may impede detection,
G
where animals will pass by (dogs, cats, etc.)
G
A Phillips screwdriver
G
A drill with a 6mm concrete bit,
G
The battery (supplied),
G
The fixing kit (supplied): 1 wall mount, 1 adjustment axis, 2 long fixing screws, 2 plugs,
G
1 tightening screw, 1 washer, 1 securing screw.
INSTALLATION INSTRUCTIONS
FIG. A
Front view
Detector lenses.
Œ
mount.
Two fixing points.
‘
FIG. B
Opening the detector case
Open the detector case by removing the securing screw.
FIG. C
Guarantee sticker
Remove the pre-cut section of the guarantee sticker, which is on the electronic card,
G
(open the back cover) and stick it on to the guarantee extension request supplied with the
base unit documents.
If you are adding to an existing system, use the guarantee extension request supplied
G
with this guide/notice.
FIG. D
Power source
Clip the battery onto the connector, respecting the polarity
FIG. E
F
and
The detector must be coded by programming using the programming indicator light and
the
and
keys.
0
1
Programming the personalised radio code
G
Code the detector after coding the base unit.
When you unwrap the detector, the radio code programmed is identical to a virgin code
(no connections have been cut on the coding bar).
YOU WILL NEED
. (Pozidriv n° 1),
®
Test indicator light.
Adjustment axis.
’
Coding the detector
Test button.
Ž
Base.
“
(Fig.
E)
Securing screw.
GB
Wall
27
Advertenties
Inhoudsopgave
