Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
28 Progress
Problem
There is too much frost and
ice.
Water flows on the rear plate
of the refrigerator.
Water flows into the refriger‐
ator.
Water flows on the floor.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not wrap‐
ped properly.
Temperature is set incor‐
rectly.
During the automatic de‐
frosting process, frost melts
on the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are
stored at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened
often.
There is no cold air circula‐
tion in the appliance.
Solution
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet‐
ter.
Refer to "Operation" chap‐
ter.
This is correct.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Make sure that there is cold
air circulation in the appli‐
ance.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
