Inhoudsopgave
Advertenties
9.
Grease both ends of the packing spring and place it over the packing seal assembly in the
gun head.
10.
Place the end cap over the packing spring so that the pilot inside the end cap seats inside the
packing spring.
11.
Push the end cap toward the gun head while threading it into the gun head. Using a wrench,
tighten the end cap securely.
12.
Perform the "Adjusting the Packing Seal Assembly" procedure described below.
Adjusting the Packing Seal Assembly
Proper adjustment of the packing seal assembly
is essential to ensure positive shut-off when the
trigger is released.
1.
Insert an 1/8" hex wrench through the hole in the center of the end cap until it seats inside the
packing seal adjustment screw.
2.
Turn the packing seal adjustment screw until the ball on the packing seal assembly can be felt
seating into position. Then, turn the screw 1/4 turn more for proper tension.
Replacing/Removing the Filter
1.
Pull the bottom of the trigger guard forward so that it comes loose from the handle assembly.
2.
Loosen and remove the handle assembly from the gun head.
3.
Pull the old filter out of the gun head.
4.
Slide the new filter, tapered end first, into the
gun head.
5.
Place the handle seal into the gun head with
the flat side of the seal toward the gun head.
6.
Thread the handle assembly into the gun
head until secure.
7.
Snap the trigger guard back onto the handle
assembly.
Filter Chart
Parts list, page 66
AG-14
Part
Application
Number
0034383
Synthetic resin,
enamels, clean
varnishes, stains
azures
0043235
Base coat enamels,
primer enamels,
fillers, marking paints,
textured enamels
0034377
Emulsions,
latex paints,
acrylic paints
0089323
Filler paints,
large area surfaces
GB
Flat side of
handle seal
(toward gun head)
Filter
Type
Extrafine
Fine
Medium
Coarse
Bevelled side of
handle seal
(toward handle)
Color of
Filter
Body
red
yellow
white
green
15
Advertenties
Inhoudsopgave
