Advertenties
Beschikbare talen
Beschikbare talen
Let the machine run for a short period of time and in a safe position. If the
machine does not run easily, stop working immediately.
Use only original accessory!
Dust Extraction
Dust which occurs during your work is hazardous to health. That is why the
ELS 125 D must be used with a vacuum cleaner (dust category M), and a
dust mask has to be worn. The suitable Wet/Dry Vacuum Cleaner DSS 25
M / DSS 35 M iP is available as accessory. It can directly be attached to
the connection (2) on the dust hood.
Changing
the
brush rim
If the length of the
brushes is – due to
wear - smaller than
5
mm
(extreme
formation of dust
during grinding), the brush rim has to be replaced completely.
Connect the lead cable of the long reach renovation grinder with the
industrial vacuum cleaner and then connect the extraction hose with the
dust connection (2) of the grinder. Lead the extraction hose and the cable
to the back away from the machine. Activate the switch-on automatic on
the vacuum cleaner.
Switch the machine on and put it carefully on the surface you want to work
on. Hold the machine with both hands and move it in a linear or rotary way.
The suction hose can be locked against slipping
out by means of the hose fixing.
Make the necessary drill hole as follows:
Put the suction hose in the connector.
Mark the plug-in depth with a crayon.
Drill 13 mm from this marking (line) a hole with
diameter 6 mm in the nozzle.
Handling
21
Advertenties
