Advertenties
Beschikbare talen
Beschikbare talen
Safety Instructions
Safe work with this machine is only possible if you read
this operating instruction and follow them strictly.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training. Save all
warnings and instructions for future reference.
If the connection cable gets damaged or cut during use, do
not touch it, but immediately pull the plug out of the socket,
Never use the tool with a damaged connection cable.
The tool must neither be wet nor used in humid environment.
This electric power tool must be used as a sander. Observe all
safety information, instructions, diagrams and data which you
receive with the power tool. If you do not observe the following
instructions, an electric shock, fire and/or serious injuries may occur.
This electric power tool is not suitable for use with sandpaper,
wire brushes, or for polishing and cut-off grinding. If the electric
power tool is not used as intended, the user may be exposed to
hazards and may be injured.
Never use accessories that were not specially developed and
intended for this machine. Just because an accessory part can be
fitted on your machine does not guarantee danger-free operation.
The permissible rotational speed of the accessory must be at least
as high as the maximum speed specified on the machine.
Accessories that rotate faster than the permissible level can rupture.
The outside diameter and the thickness of accessories must be
within the specified size range of the machine. Accessories with
incorrect dimensions cannot be sufficiently protected or controlled.
Diamond grinding wheels must fit exactly on the grinding spindle
of your electric power tool. Insertion tools, which do not fit exactly on
the grinding spindle of the electric power tool, rotate unevenly, vibrate
violently and may result in loss of control.
Do not use damaged accessories. Before use, always check
accessories such as sanding pads for nicks or cracks and check
support plates for cracks and excessive wear. Every time the ma-
chine is dropped, check the machine and accessories for damage,
or install undamaged accessories. Following the check and
assembly of accessories, ensure that all persons are beyond the
rotating range of the tool and run the machine for one minute at
maximum speed. Damage accessories usually break completely
during this test time.
17
Advertenties
