Advertenties
Beschikbare talen
Beschikbare talen
Electrical Connection
First, check the correspondence between voltage and frequency against
the data mentioned on the identification plate. Voltage differences from
+ 6% to – 10% are allowed.
The ELS 125 D is made in protection class I.
Only use extension cables with a sufficient cross-section. A cross-section
which is too small might cause a considerable drop in performance and an
overheating of machine and cable.
Before connecting the machine to the mains supply, make sure that
the machine is switched off.
Adjustable handle
The adjustable handle can be adjusted continuously depending on the user
(see Fig.2). For this purpose loosen the two wing bolts (arrows).
Push the handle to the desired position and close the thumbscrews.
Switching on and off
The ELS 125 D is equipped with a lock-off button against
unintentional switch-on.
Switching-on: push the lock-off button forward (1)
and then the on/off switch down (2)
Switching-off: release the on/off switch
Tool Change
Attention!
Before the beginning of all works disconnect the plug from
the mains!
Attention!
The grinding wheel might heat up enormously during operation. You
could burn your hands or get cut or ripped by the segments.
Therefore, always use protective gloves when changing the grinding
wheel.
First of all, the detachable hood segment (3) has to be opened.
Now you can hold up the driving disc between gearbox and grinding wheel
by using a jaw wrench 32. Use the face spanner to unscrew the driving nut.
Then remove the mounted grinding wheel respectively mount the new one.
The assembly works the other way round!
20
2
1
Advertenties
