Fault Rectification - User; Fault Rectification - Qualified Installer; Environment And Recycling; Customer Service And Guarantee - Stiebel Eltron SH 30 S electronic Gebruiks- En Montagehandleiding
Gesloten wand
Verberg thumbnails
Zie ook voor SH 30 S electronic:
- Handleiding voor bediening en installatie (14 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3. Fault rectification
Fault
No hot water.
Small throughflow.
Low mixed water volumes.
„SERVICE ANODE" signal lamp lights up.
Table 2
4. Fault rectification
Fault
No hot water.
Small throughflow.
Low mixed water volumes.
„SERVICE ANODE" signal lamp lights up.
Table 3
5. Guarantee
For guarantees please refer to the pespective
terms and conditions of supply for your
country.
The installation, electrical connection
and first operation of this appliance
should be carried out by a qualified
installer.
The company does not accept liability for
failure of any goods supplied which accor-
dance with the manufacturer's instructions.
by the user
Info
No voltage.
Dirt contamination or limescale deposits on
the perlators in the fittings or the shower
heads.
Temperature setting too low.
Heating element blocked with limescale.
Signal anode used up.
by thequalified installer
Info
No voltage.
Dirt contamination or limescale deposits on
the perlators in the fittings or the shower
heads.
Temperature setting too low.
Heating element blocked with limescale.
Signal anode used up.
6. Environment and
recycling
Recycling of obselete appliances
Appliances with this label must not
be disposed off with the general
waste. They must be collected
separately and disposed off according to local
regulations.
Rectification
Check the fuses in the house electrical
installation.
Clean and/or clear the limescale from the
outlet fittings.
Increase the temperature setting.
Arrange for the qualified installer to remove
limescale from the heating element.
Arrange for the qualified installer to check
the signal anode and replace it if necessary.
Rectification
Establish voltage supply.
Clean and/or clear the limescale from the
outlet fittings.
Increase the temperature setting.
Remove limescale from the heating element.
Check the signal anode and replace it if
necessary.
15
Advertenties
Inhoudsopgave
