Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
c) Mounting the Device
Remark
: Please consider the contents of EN 60598-2-17 and your own national norms during installation. A
qualified technician should carry out the installation!
• The supporting structure for the device must be able to carry 10 times the required weight for one hour without
deformation of that structure.
• The installation must always be secured by a secondary safety attachment e.g. a safety cable (VDLSC7 or
VDLSC8).
• Do not stand directly below the device when mounting, removing or repairing it. Have a qualified technician check
the installation once a year and once before you bring the device into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating work load limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Make sure there is no flammable material within a 50cm radius of the device.
• Place the device in the desired angle using the mounting bracket and fix it in that position with the bracket screws.
• A qualified electrician should carry out the electric connection.
• Connect the device to the mains with the power plug. In general, lighting effects should not be connected to
dimming packs.
• The installation has to be approved by an expert before the device is taken into service.
• Adjust the music sensitivity of the built-in microphone by turning the knob on the rear panel of the device.
5. Cleaning and Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, mounting supports and connections should not be modified or tampered with e.g. do not drill extra
holes in mounting supports, do not change the location of the connections...
3. The electric power supply cables should be undamaged. Have this device installed by a qualified technician.
4. Mechanically moving parts must not show any signs of wear and tear.
6. Caution
• Disconnect the device from the mains prior to maintenance.
• Use a moist cloth to clean the device and avoid the use of alcohol or solvents for cleaning purposes.
• This device does not contain any user-serviceable parts with the exception of the lamps and the fuse. Refer to "a)
Installing or Replacing a Lamp" and "b) Replacing the Fuse under "Installation" for further details.
• Spare parts should be ordered with your local dealer.
7. Technical Specifications
Power Supply
Power Consumption
Fuse
Dimensions
Weight
Lamp
Max. Ambient Temperature
Max. Housing Temperature
The information in this manual is subject to change without prior notice.
VDL3002MR_v2
Procedure
max. 230Vac/50Hz
max. 600W
5A/250Vac (5 x 20mm)
Ø270 x 380mm
3.5kg
2 x 300W / 120V JDC G6.35
45°C
130°C
5
VELLEMAN
Advertenties
Inhoudsopgave
