Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Translation of the original instructions
Do not place the device near a fire or subject
it to heat or to longterm temperatures exceeding
60°C.
Do not obstruct the cooling vents. Refer to the in-
stallation section before operating the machine.
The automatic mode of operation and usage re-
strictions are explained below in these operating
instructions.
The booster must be stored in a vertical position.
Any other storage position should only be
temporary.
Risk of explosion or acid projection in case of
short-circuit of the clamps or if the 12V booster is
connected to a 24V vehicle or vice versa.
The automatic mode of operation and usage re-
strictions are explained below in these operating
instructions.
Risk of explosion and fire!
A battery being charged can emit explosive gas.
• During the charge, the battery must be placed
• Avoid flames and sparks. Do not smoke.
• Protect the electrical contacts of the battery
Connection / disconnection:
• Disconnect the power supply before connect-
• The terminal of the battery that is not connected
• After the start-up operation, disconnect the boost-
Acid projection hazard!
10
GYSPACK 400 / 600
in a well ventilated area.
against short-circuiting.
ing/disconnecting the device to/from the bat-
tery.
to the car frame must be connected first. The oth-
er connection must be made on the car frame,
far from the battery and the fuel line.
er. First remove the chassis connection and then
the battery connection, in the order shown.
EN
Advertenties
Inhoudsopgave
