Advertenties
Beschikbare talen
Beschikbare talen
Cleaning and maintaining the LCD monitor
7.3
Setting the monitor
To set the monitor to suit your requirements, proceed as follows (fig. 0, page 6):
➤ Press the "
" button (5) to call up the required parameter.
✔ The parameters to be set are displayed in the following sequence:
– Brightness: 0 – 100
– Contrast: 0 – 100
– Saturation: 0 – 100
– Volume: 0 – 100
– Language: English, French, German
– Mirror AV1/AV2/AV3/AV4: Yes or No
– Video AV1/AV2/AV3/AV4: Yes or No
– Distance grid: ON or OFF
– Trailer detection: ON or OFF
– Day/night mode: ON or OFF
– Default: Default setting for all parameters
➤ Press the "+" button (3) or the "–" button (4) to set the required parameter.
➤ Press the "+" button (3) to increase the value of the selected parameter.
➤ Press the "–" button (4) to reduce the value of the selected parameter.
7.4
Setting the video source
Proceed as follows to set the video source (fig. 0, page 6):
➤ If you would like to switch to a different video source, press the
✔ The monitor changes the camera in the order Camera 1 – Camera 2 – Camera 3 – Camera 4.
With the Video AV1/AV2/AV3/AV4 parameter, video inputs that are not used can be switched to
inactive. These empty inputs are then skipped over.
7.5
Detecting the trailer camera
This function is required when using a trailer camera (fig. c, page 7) if the system is activated auto-
matically via the reverse gear.
• One camera connected (e.g. towing vehicle without a trailer):
the camera connected to AV1 (1) is activated.
• Two cameras connected (e.g. towing vehicle with a trailer):
the camera connected to AV4 (2) is activated (AV1 is inactive).
8
Cleaning and maintaining the LCD monitor
A
NOTICE! Risk of damage!
• Do not use sharp or hard objects for cleaning, as these may damage the monitor.
• Remove the cable before cleaning the monitor to prevent short circuiting.
➤ Clean the monitor with a soft, damp cloth from time to time.
18
button (6).
M71L
EN
Advertenties
