Advertenties
Beschikbare talen
Beschikbare talen
M71L
I
NOTE
If voltage is present at the green cable (7), the reversing camera is activated. The
reversing camera has priority.
➤ If the monitor is to be activated e.g. when the indicator is flashing, connect the following control
cable to a positive cable of the indicator:
– white cable (8), blue cable (13)
I
NOTE
If voltage is present in this control cable, the video inputs AV2 and AV3 will be acti-
vated.
This control cable is used as a signal cable for the activation of a side camera when an indicator is
flashing, for example.
➤ If necessary, connect the AV1 socket (9) of the connection cable to the plug of video source 1
(e.g. reversing camera).
➤ If necessary, connect the AV2 socket (10) of the connection cable to the plug of the video
source 2 (e.g. side camera).
➤ If necessary, connect the AV3 socket (11) of the connection cable to the plug of video source 3
(e.g. camera).
I
NOTE
Observe the power consumption of the video system. The cameras are equipped with
heaters. A maximum current of 1.5 A can flow (three cameras in heating mode). Use a
disconnecter switch for direct connection to the battery. This allows you to disconnect
the video system from the battery easily if you are no longer using the vehicle.
Connecting an additional reversing camera (trailer operation)
➤ If necessary, connect socket AV4 (12) of the connection cable to the plug of the additional
reversing camera.
7
Using the LCD monitor
7.1
Switching on the monitor
➤ If the monitor is switched off, press the
➤ The button lights up blue.
✔ The picture appears.
7.2
Switching off the monitor
➤ Press the
button (fig. 0 2, page 6) to switch off the monitor.
➤ The button lights up red.
✔ The picture disappears.
EN
button (fig. 0 2, page 6) to switch the monitor on.
Using the LCD monitor
17
Advertenties
