Advertenties
Beschikbare talen
Beschikbare talen
Installing the LCD monitor
No.
9
10
11
12
13
A
NOTICE!
Cables and cable connections that are not properly installed will cause malfunctions or
damage to components.
Correct installation of cables and cable connections ensures lasting and trouble-free
operation of the retrofitted components.
Observe the following instructions when laying the connection cables:
• If possible, use existing through-holes for feeding through the connection cables, or other suit-
able options, such as ventilation grilles. If there are no existing through-holes, you must drill a
hole of ∅ 22 mm. Check beforehand that there is sufficient space on the other side for the drill
head to emerge (fig. 2, page 4).
• Cover the holes with the feed through (fig. b 1, page 7) in the base of the monitor bracket.
• To prevent damage to the cables, when laying them ensure that there is always a sufficient dis-
tance to vehicle components which can become hot (lights, heaters, ventilators etc.).
• When laying the cables (fig. 3, page 4), make sure:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged through-holes without protection
Connecting the monitor as a reversing video system (fig. d, page 8)
➤ Lay the connection cable for the monitor bracket on the dashboard.
➤ Insert the plug of the monitor cable (2) into the socket (4) of the connection cable (3).
Wait until you hear the plug snap in.
A
NOTICE! Risk of damage!
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black cables of the connection cable to a suitable voltage supply:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤ If the monitor is to be activated when reverse gear is selected, connect the green cable (7) to
the positive cable of the reversing light.
16
Description
6-pin AV1 socket (connection to video source 1)
6-pin AV2 socket (connection to video source 2)
6-pin AV3 socket (connection to video source 3)
6-pin AV4 socket (connection to video source 4,
with video signal detection) (optional)
Cable (blue): control input for video input AV3 (optional)
M71L
EN
Advertenties
