Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Translation of the original instructions
Regulations :
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
• Equipment in compliance with British requirements. The British
Declaration of Conformity is available on our website (see
home page).
• Equipment in conformity with Moroccan standards. The
declaration C( مCMIM) of conformity is available on our
website (see cover page).
Disposal:
• This product should be disposed of at an appropriate
recycling facility. Do not dispose of in domestic waste.
GENERAL DESCRIPTION
The NEOSTART range is designed to charge and start lead-acid batteries, 12V (6 elements) and 24V (12 elements) :
Assembling the handle and the wheels (only for the NEOSTART 420 et 620 ) :
POWER SUPPLY
Check that the power supply and its protection (fuse and/or circuit breaker) are compatible with the current needed by
the machine. The device must be positioned so that the socket is always accessible.
The machine must be connected to a single phase socket (230 V) WITH earth protected by a 16A circuit breaker.
CONNECTION AND DISCONNECTION
IMPORTANT ! Before any connection to a vehicle battery, make sure that the booster isn't connected to the mains and
that the booster's switch is set to OFF (if applicable).
Also, check the battery polarity.
Warning : the cables must not be kinked or in contact with hot or sharp surfaces.
• Disconnect any electronic system from the battery during the charge (do not charge the battery when it's connectd
to the vehicle).
NEOSTART 320 / 420 / 620
Neostart 320
Neostart 420
Neostart 620
Recharge
40 - 400 Ah
25 - 600 Ah
45 - 900 Ah
Starting
35 - 120 Ah
35 - 160 Ah
45 - 200 Ah
EN
11
Advertenties
Inhoudsopgave
