Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Before starting the machine, please check the correspondence between
voltage and frequency according to the data mentioned on the identification
plate. Voltage differences of + 6 % and – 10 % are allowed.
The contra twin stirrer is made in protection class II. Only use extension
cables with a sufficient cross section. A cross section which is too small
could cause a considerable drop in performance and an overheating of
machine and cable.
The EZR 21 R is equipped with a soft start.
Tool Protection
Wrong handling can cause damages on the tool.
Therefor, please always observe the following instructions:
Only use original EIBENSTOCK stirring rods.
Do not allow blocking of the tool.
Switching on and off
Short-Time Operation
Switching-on:
press the on/off switch
Switching-off:
release the on/off switch
Permanent Operation
Switching-on:
press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off:
press the on/off switch and release it again
Attention!
Only press the arrestor button when using a
!
stand. In case of every stop of the machine, the
arrestor button has to be released immediately by
pressing the on/off switch. Consequently you can
avoid an unintentional restart of the machine
(physical hazard).
The EZR 21 R is equipped with an adjusting wheel in order to preselect the
required speed. The adjusting wheel is on the top side of the switch handle
(I – minimum, IIIIIII – maximum). The integrated electronics automatically
realises the soft start of the machine. Please pay attention that in case of
Electrical Connection
13
Advertenties
Inhoudsopgave
