INSTaLLaTION
appliance description
7.2
Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
The specific electrical resistance of the water used must not fall
below that stated on the type plate. In a linked water network,
factor in the lowest electrical resistance of the water (see chapter
"Specification / Data table"). Your water supply utility will advise
you of the electrical resistivity or conductivity of the water in your
area.
8.
Appliance description
8.1
Standard delivery
The following are delivered with the appliance:
- Sieve inside the cold water inlet
- Special aerator
- Connection hose 3/8, 500 mm long, with gaskets*
- Tee 3/8*
*for the connection as pressure-tested appliance
www.stiebel-eltron.com
8.2
Accessories
Special aerator
Note
Fitting the special aerator supplied provides an optimum
water jet.
Taps/valves
f Use suitable taps.
Pressure-tested taps
Suitable pressure-tested taps are available from specialist trade
shops.
Non-pressurised taps
- MAW (OT) - Non-pressurised wall mounted tap
- MAZ (UT) - Non-pressurised twin lever basin tap
- MAE (UTE) - Non-pressurised mono lever basin tap
EIL Plus |
9