Cleaning the filter assembly
1
Caring for the dishwasher
To clean the control panel use a lightly dampened cloth then dry thoroughly.
Protect against freezing
The dishwasher must always be placed in a frost-free room.
Cleaning the spray arm
It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm jets and bearings.
1
Cleaning the door
WARNING !
Never use a spray cleaner to clean the door panel for it could damage the door lock and electrical components. It is not allowed to use
the abrasive agent or some paper towel because of the risk of scratching or leaving spots on the stainless steel surface.
For best performance and results, the filter assembly must be cleaned.
The filter efficiently removes food particles fromthe wash water, allowing it to be recirculated
during the cycle. For this reason, it is a good idea to remove the larger food particles trapped
in the filter after each wash cycle by rinsing the semicircular filter and cup under running
water.
1.
Contrarotate the coarse filter and then lift it up.
2
2.
Remove the main filter.
3.
Lift the fine filter up.
The entire filter assembly should be cleaned once a month.
To clean the coarse filter and the fine filter, use a cleaning brush. Then, reassemble the filter
parts in reverse order.
WARNING!
3
The dishwasher must never be used without the filters. Improper replacement of the filter
may reduce the performance level of the appliance and damage dishes and utensils.
To remove the spray arm:
Pull out the spray arm upwards.
Wash the arms in soapy and warm water and use a soft brush to clean the jets. Replace them
after rinsing them thoroughly.
To clean the edge around the door, you should use only a soft warm, damp rag. To prevent
penetration of water into the door lock and electrical components, do not use a spray cleaner
of any kind. Also, never use abrasive cleaners or scouring pads on the outer surfaces because they
will scratch the finish. Some papers towels can also scratch or leave marks on the surface.
24