WATER SOFTENER
This appliance is equipped with a water softener.
Loading salt into the softener
Always use salt intended for use with dishwasher. The salt container is located
beneath the rack and should be filled as follows:
ATTENTION:
The salt container must be refilled when the salt warning light in the control panel comes on. Though the salt
container is filled enough, the indicator light may not black out before the salt is fully dissolved.
Adjusting Salt Consumption
You can adjust the amount of salt consumed based on the hardness of the water used.
Proceed as follows:
1.
Within 60 seconds after switching on the diswasher: Press the start/reset button for 5 seconds. The rinse aid warning light and the
water softener warning light will flash alternatively.
2.
Select the level of salt consumption by repeatedly pressing the program selector button. Each program corresponds with a certain
setting, see the table below.
Water hardness
Water softener
ºdH
mmol/l
0 - 5
0 - 0,9
6 - 11
1,0 - 2,0
12 - 17
2,1 - 3,0
18 - 22
3,1 - 4,0
23 - 34
4,1 - 6,1
35 - 45
6,2 - 8,0
* Factory setting
Contact your local water board for information on the hardness of your water supply.
( The container must always be filled)
1.
Remove the lower basket and then unscrew and remove the cap from the
container.
2.
If you are filling the container for the first time, fill
water.
3.
Place the end of the funnel (supplied) into the hole and introduce about
1.2 kg of salt. It is normal for a small amount of water to come out of the
salt container.
ATTENTION: Remove spilt salt and start a washing program
immediately to prevent damage to the bottom of the diswasher.
4.
Carefully screw the cap back on.
Number of light and sound signals
setting
1
The intensive program indicator light is on and 1 signal sounds
2
The normal program indicator light is on and 2 signals sound
3*
The ECO program indicator light is on and 3 signals sound
4
The glass program indicator light is on and 4 signals sound
5
The rapid program indicator light is on and 5 signals sound
6
The 3 in 1 program indicator light is on and 6 signals sound
20
2
⁄
of its volume with
3