Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
FAULTS
General
Troubleshooting table
Symptom
A slight smell is noticeable
the first few times the hob is
used.
You can hear a ticking sound
in your hob.
A cooking zone suddenly
stops and you hear a signal.
The hob is not working
and nothing appears in the
display.
A fuse blows as soon as the
hob is switched on.
Fault code F00 / Red indicator
light next to "key" button is lit
and the indicator light above
pause button is blinking.
All manuals and user guides at all-guides.com
If you notice a crack in the glass top (however small), switch the hob
off immediately, unplug the hob, turn off the (automatic) fuse switch(es)
in the meter cupboard or, in the event of a permanent connection,
set the switch in the power supply lead to zero.) Contact the service
department.
If the appliance does not work properly, this does not always mean that
it is defective. Try to deal with the problem yourself first by checking
the points mentioned below.
Attention
If the square red light above the pause button flashes (and none of the
malfunctions below apply) please contact the service departement.
Possible cause
The new appliance is heating
up.
This is caused by the
capacity limiter on the front
and back zones. Ticking can
also occur at lower settings.
The preset time has ended.
There is no power supply
due to a defective cable or a
faulty connection.
The hob has been wrongly
connected.
The control panel is filthy or
has water on it.
Solution
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
Normal operation.
Switch off the audible sound
by pressing the + or - button
of the timer.
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Clean the control panel
EN 23
Advertenties
Hoofdstukken
Inhoudsopgave
