Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION
Additional requirements for the integration (flush installation) of the hob
(HL8271I)
min. 800 mm
for HL8271I
EN 30
All manuals and user guides at all-guides.com
• The hob can only be integrated above a single cupboard at least
800 mm wide (see illustration).
• Once it has been integrated, the hob must remain accessible from
underneath for service purposes.
• If a drawer or oven is built in under the hob it must be easily
removable.
• These hobs are particularly suitable for integration in stone or tiled
worktops.
• When integrating the hob it should only be kitted along the side of
the glass top and not at the bottom. This is to ensure that the glass
top itself remains accessible should it need to be replaced.
To do this, apply a layer of tape, such as masking tape, to the inlay
surface.
• Report any transit damage before sealing the hob. Any damages
reported afterwards will be deemed a result of it being built in.
• The guarantee does not cover damages resulting from the hob
being built in.
• The guarantee does not cover water damage or any other damage
to the worktop the hob is built into.
• Prior to any service call, all interior parts of the cupboard the hob is
built into, such as drawer constructions, shelves, racks and runners,
are to be removed.
• The service department is responsible for the repair and service of
the hob only. You should contact your kitchen specialist about the
re-integration (flush installation) of the hob.
• The kit used to seal the edges of the glass top must be resistant to
temperatures of at least 160 °C.
• To prevent discolouration of the natural stone, use a specially
developed sealant between the glass and natural stone.
Advertenties
Hoofdstukken
Inhoudsopgave
