Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
26 Progress
Problem
You cannot activate the outer
ring.
There is a dark area on
the multiple zone.
The sensor fields become
hot.
comes on.
comes on.
and a number come on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error
INSTALLATION
WARNING! Refer to Safety
chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
Possible cause
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large or
you put it too near to the
controls.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is an error in the hob.
message that comes on. Make sure, you
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee
are in the guarantee booklet.
Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.
Connection cable
• For a single phase or two phase
connection use the following (or higher)
mains cable type: H05V2V2-F T min
90°C.
Remedy
Activate the inner ring first.
Put large cookware on the
rear zones if possible.
Deactivate the hob and acti-
vate it again.
Refer to "Daily use" chapter.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If
comes on again, speak
to an Authorised Service
Centre.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
