Advertenties
Beschikbare talen
Beschikbare talen
1
53
2
55
80
51
Connecting the motor cable
•
M ake sure that you have remounted the front
wheel to the bike in accordance with the instructions.
•
M ake sure that the cable from the motor axle falls
into the front fork's recess at the underside, or else
you will damage the motor cable.
•
M ake sure that the motor cable is clamped behind
the 2 cable guide brackets and firmly press the
cable to the recess in the front fork. (Photo 51)
52
•
R econnect the two ends and refit the transparent
crimp sheath. Fit a new, small cable tie to the lower
section of the crimp sheath to ensure it remains
watertight, and refit the cables in the connector
casing. (photo 52)
•
Feed both the upper and lower sections of cable
behind the securing clips (1 and 2). (photo 53)
•
W hen a replacement is made, you must also
replace the pull tie. This is necessary to guarantee
water tightness.
•
A ttach the front part of the cap with the 2 Allen
screws. Make sure that the two halves connect
properly and that no cables interfere.
(Photos 54 + 55)
•
S lide the battery back into the bike and check if
the display is working.
54
Advertenties
