Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
26 progress
Problem
The temperature in the
freezer is too high.
There is too much frost.
Replacing the lamp
1. Remove the screw from the lamp cov-
er.
2. Remove the lamp cover (refer to the il-
lustration).
3. Replace the used lamp with a new
lamp of the same power and specifical-
ly designed for household appliances.
(the maximum power is shown on the
lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the mains plug to the mains
socket.
7. Open the door. Make sure that the
lamp comes on.
TECHNICAL DATA
Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
Possible cause
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not
set correctly.
Height
Width
Depth
Store products so that there is
cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1580 mm
560 mm
550 mm
20 h
230-240 V
50 Hz
climate class indicated on the rating plate of
the appliance:
Solution
Advertenties
Hoofdstukken
Inhoudsopgave
