Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Installation Manual : Scope of the warranty
6.3 Maintaining the tank
Check the condition of the magnesium anode every two years and replace it if its diameter is less than
10 mm. It is strongly recommended to have maintenance performed on the tank by a professional every
2 - 3 years depending on the quality of the water: draining and limescale removal. In areas where
the water is hard, it is possible to treat the water with a softener. This should be regulated and the water
hardness should remain greater than 8°f.
Using a softener does not invalidate our warranty as long as it is used in accordance with professional
standards, and is checked and maintained regularly.
Do not throw your appliance away in the domestic waste, but take it to a specially designated
place (collection point) where it can be recycled.
6.4 Magnesium anode replacement for stationary accumulators
Check the magnesium anode by visual inspection:
Tools required:
1x socket spanner with nut SW 32
1.
If there is electrical built-in heating, disconnect the electrical supply and secure it against being
switched on again
2.
If available, switch off the circulation pump!
3.
Shut off the cold water pipe with a stopcock!
4.
Depressurise the storage tank by opening the hot water tap and lower the water in the storage tank
by means of the safety valve!
5.
Unscrew the 5/4» screw connection using a suitable tool, socket spanner with SW 32 nut!
6.
Replace the old magnesium anode with the new magnesium an-ode!
7.
Screw in new 5/4» screw connection with new magnesium anode up to the screw plug collar!
8.
Open the cold water tap and refill the storage tank!
9.
The hot water storage tank is completely filled when water runs out of the outflow pipe of the valve
without any bubbles!
10. Check for any leakage!
11. If there is electrical built-in heating, restore the electrical supply and check the function
31
Advertenties
Hoofdstukken
Inhoudsopgave
