Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
PROTECTION position
2
1
1
The air vacuum system head is in "service" position
2
Turn the plunger to the left
3
Move the plunger to the low position. The air vacuum
system head is now in "protection" position
Protecting your open bottles from oxidation:
1
Open the compartment door.
2
If the air vacuum system head is in the protection
position, place the neck of the open bottle directly
under one of the air vacuum plungers and raise the
bottle whilst centring it vertically in the bottle holder
(ensure that there are no objects that could obstruct
the bottle neck).
1
2
Removing a bottle
1
Open the compartment door
2
Remove the bottle without handling the air vacuum
system head.
3
If need be, place the air vacuum system head in "serving"
mode. We do not recommend that you activate vacuum
sealing each time you handle the bottle but rather at
The lighting of your appliance:
Your Wine Bar 2.0 has multicolour LED lighting. It is supplied with a
remote control for setting the lighting functions.
The sensor of the lighting controller is located on the front between
the two doors. When using the remote control, always ensure that
you are standing in front of the appliance.
The remote control can be stored by placing it against the back cover,
thanks to the magnet.
-GB10-
SERVING position
2
1
3
1
The air vacuum system head is in "protection"
position. Raise the plunger
2
Turn it to the right to maintain it in its upper position.
3
The air vacuum system head is now in "service"
position
3
If the air vacuum system head is in serving position,
first place it in protection mode. To do so, turn the
plunger to the left to release it and move it down to
the low position.
Then place the neck of the open bottle under the air
vacuum plunger and raise the bottle until it is in the
vertical position
4
The air vacuum system then activates itself for a few
seconds (the appliance is then operating independently),
5
Close the compartment door
3
the end of service or when you have finished using the
appliance (vacuum sealing a bottle repeatedly can affect
the duration of preservation of wine).
4
Close the door
N.B: The pump will activate itself again (which is normal)
for approximately 10 seconds.
M
1
2
3
4
Light
M
M
M
OPERATION:
1
2
3
4
1
2
3
4
1
2
3
4
Press once to activate the lighting mode.
M
M
Light
Light
Light
1
2
1
3
2
4
3
4
ON / OFF
3
M
M
Light
Light
Automatic colour variation or pause.
1
2
3
4
M
1
2
3
4
3
1
2
4
Light
Setting colours. Pressing one of these keys will cause the automatic colour
M
Light
variation function to stop.
Light
3
1
2
4
M
Setting brightness, valid only for fixed lighting.
Light
1
2
3
4
Setting the speed of colour variation, or sensitivity for the music function.
M
Light
Music mode: the colours vary according to the sound intensity.
1
2
Light
Save function
M
1
2
3
4
The save function can only be used in fixed colour mode.
Light
Press
Set the desired colour by pressing
Press
M
The colour is stored on the key selected.
1
Whenever you press this key the stored colour will appear.
Light
Use of the remote control with several appliances
3
4
M
M
1
1
2
2
3
3
4
4
Light
Light
to vary the colours. Press again to select.
or
.
M
M
then
or
1
2
1
2
3
4
3
4
2
3
4
Light
Light
Independent operation:
Aim at the sensor zone, at a distance of less than
25 cm
Simultaneous operation:
Aim at the zone indicated, at a distance of more
than
- 20 cm for 2 appliances
- 110 cm for 3 appliances
- 160 cm for 4 appliances
Comment: In colour sequence mode, it is not
possible for all the products to be synchronised.
M
1
2
3
4
Light
-GB11-
Advertenties
Hoofdstukken
Inhoudsopgave
