2 - IMPORTANT SAFETY RECOMMENDATIONS
Carefully read these operating instructions before using your appliance for the first time and retain them for future
reference.
Using your appliance in a way that does not comply with the operating instructions may damage it.
•
Never use the appliance for anything other than its specific purpose, as described in these operating instructions
•
Unplug your appliance when you are not using it for extended periods.
•
Before carrying out any servicing or maintenance, unplug the appliance.
•
Never unplug the appliance by pulling the cable, but by the plug.
•
Never use a split power lead or one showing signs of wear along its length.
•
Immediately replace damaged leads (contact your Eurocave Professional dealer).
•
Only use the mains transformer supplied with the appliance, only plug it into an earthed wall socket.
•
Check that the voltage of your electrical installation corresponds to that of the mains transformer supplied with the
appliance.
•
Your appliance is only intended for indoor use (ideal operating ambient temperature 10°C-35°C / 50°F-95°F with a
maximum ambient air humidity level of 80 %).
•
If the cable, plug or appliance appear to be damaged or are not functioning correctly, contact your Eurocave Professional
dealer.
•
Never put the appliance, power lead or plug in water or any other liquid. Never fill the appliance with water or other
liquid.
•
Do not let the power lead hang within reach of children, over a square corner or close to a source of heat.
•
Do not place the appliance on a hot surface such as a hotplate, do not use close to a source of heat (radiator, naked
flame, window...).
•
Place the appliance on a flat, stable and non-flammable surface, at a suitable distance from sinks or taps, to avoid splashes
from water or other liquid.
•
This appliance was not designed to be used by persons (including children) with reduced physical, sensorial or mental
abilities, or by persons without experience or knowledge, except when they benefit, by a person responsible for their
safety, from supervision or prior instructions on how to use the appliance. Children should be supervised to ensure that
they do not play with the appliance. The manufacturer shall not be held responsible for damage caused by misuse or
incorrect handling of the appliance and the warranty shall be rendered null and void in such cases.
•
Do not obstruct the ventilation inlets at the back or sides of the appliance. The ventilation inlets must be situated at a
distance of at least 5cm from any walls or objects.
3 - POWER SUPPLY
If you are moving to a foreign country, check whether or not the appliance's characteristics correspond to the
country (voltage, frequency).
-GB6-
The appliance's power lead has a plug to be plugged into a standard
earthed socket to prevent any risk of electric shock.
Have the mains socket inspected by a qualified electrician
who will check that it is correctly earthed and will carry out,
if need be, work to bring your installation into line with
standards.
Contact your usual Eurocave Professional dealer to change the power
lead if it is damaged. It must be replaced by a Eurocave Professional
part which has an original manufacturer's guarantee.
4 - PROTECTING THE ENVIRONMENT
•
Disposing of packaging
•
The packaging used by Eurocave Professional is produced in recyclable materials.
•
After unpacking your cabinet, take the packaging to a refuse collection point. For the most part,
it will be recycled.
•
Recycling: a caring gesture
•
Electronic and electrical equipment has potentially harmful effects on the environment and human
health, owing to the presence of dangerous substances.
•
Therefore, you must not trash electrical and electronic equipment with non-sorted municipal
waste.
•
When purchasing a new Eurocave Professional product (wine cabinet, cellar conditioner, Vin au
Verre, Wine Bar 2.0), you can entrust the recycling of your old appliance to your Eurocave Professional dealer.
•
Speak to your Eurocave Professional dealer, he will advise you on the disposal and collection arrangements set up
within the Eurocave Professional network.
•
In compliance with legislation on protecting and caring for the environment, your appliance does not contain C.F.C.s.
•
Energy-saving
•
Install your cabinet in a suitable location and observe the recommended temperature ranges.
•
Keep the door open for as short a time as possible.
•
Ensure that the door seal is in good condition and that it is not damaged. If they are, contact your Eurocave
Professional dealer.
Disable unusable appliances by unplugging them and removing the power lead.
•
Check, when your cabinet is delivered, that it does not have any external faults (impact, warping...).
•
Open the door and check the integrity of your appliance (walls, air vacuum heads, electronics and air vacuum system).
If there is a problem, contact your Eurocave Professional dealer.
Installation
Transport your appliance to the chosen location.
It must:
•
be open on the outside to allow air to circulate
(not a closed cupboard...)
•
not be close to any heat source,
•
not be too damp,
•
have a stable, flat support,
•
have a power supply (standard socket, 16 A, earthed with circuit breaker, 30 mA* (*not applicable to some countries).
Precautions
•
Do not place your cabinet in an area likely to be flooded.
•
Do not position your cabinet near to a source of heat or expose it to the effects of direct sunlight.
•
Prevent water from splashing on the entire rear section of the appliance.
•
Position your appliance so that there is a minimum space of 5-10 cm between the wall and the rear wall of your cabinet.
•
Arrange the power lead so that it is accessible and does not come into contact with any component of the appliance.
•
Ensure that the mains transformer is placed away from any heat source.
•
Do not obstruct the ventilation holes at the back of the appliance.
Any LEDs must only be replaced by a qualified electrician.
Do not plug several appliances into a multi-socket and do not use an extension cord.
AND ENERGY-SAVING
5 - INSTALLATION
-GB7-