Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
1
Safety
Warning indications
The following warning indications are used in this manual in the con-
text of safety:
Indicates that great potential danger exists that can lead to serious
injury or death.
Indicates that a potential danger that can lead to injury exists.
Indicates that the usage procedures, actions etc. concerned can re-
sult in serious damage to property. Some CAUTION indications also
advise that a potential danger exists that can lead to serious injury
or death.
Emphasises important procedures, circumstances etc.
Symbols
Indicates that the relevant procedure must be carried out.
Indicates that a particular action is forbidden.
Pass on the safety instructions to others using the E-Line motor.
General rules and laws concerning safety and accident prevention
must always be observed.
vetus® Installation instructions and operation manual E-Line electric propulsion
D
anGer
W
arninG
c
aution
n
ote
Make sure that the user of the vessel is supplied with the owner's manual .
2
Introduction
This manual give guidelines for installing a Vetus E-Line electric mo-
tor, type 'ELINE050' , 'ELINE075 en 'ELINE100' .
The quality of the installation is decisive for the reliability of the E-
Line system. Almost all faults can be traced back to errors or inac-
curacies during installation. It is therefore imperative that the steps
given in the installation instructions are followed in full during the
installation process and checked afterward.
Unauthorised modifications shall exclude the liability of the manu-
facturer for any resulting damage.
Depending on wind area, displacement, propeller, battery pack size
and shape of the underwater hull, the power delivered by the electric
motor will give a different result on each vessel.
The nominal rated power output is only achievable under optimum
conditions:
• During use ensure the correct battery voltage is available.
• The installation is carried out in compliance with the recommen-
dations given in this installation instruction, in particular with re-
gard to:
- Sufficiently large diameter of the battery cables so that voltage
drop is reduced to a minimum.
- The inflow to the propeller.
- Alignment of the propeller shaft system.
Changing over the plus (+) and minus (-) connections will
cause irreparable damage to the installation .
Check for possible leakage immediately after the ship has
been launched .
After installation of the system, before commissioning,
check the following points:
- Flexible motor mounts.
- Coolant leakage.
- All hose and cable connections, bolts, nuts and glands.
ENGLISH
W
arninG
n
ote
n
ote
370301.01
19
Advertenties
Inhoudsopgave
