Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
wood-treatment additives (chromate, wood pre
servative). Materials containing asbestos may only be
worked on by specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the work area.
– The use of a P2 fi lter class respirator is recommended.
Observe the relevant regulations in your country for the
materials to be worked.
The vacuum cleaner must be approved for the extraction
of masonry dust. WOLFF provides:
Wet and dry vacuum cleaner M30 #162780
Insert the suction hose of the vacuum cleaner in the
adapter (12) of the machine.
3.2 Saw blade removal/reinstallation Figure E
The saw blade must be replaced if the quality of the cut
deteriorates.
Remove the battery from the machine before changing the
saw blade pull out! Unintended switching on of the machi-
ne can lead to injuries, e.g. to the hands.
Before installing the saw blade, make sure that the clam-
ping fl ange and the saw blade are clean.
Dirt can lead to increased vibrations and uneven running.
Wear protective gloves when changing the saw blade to
protect yourself from cuts on the sawing surface.
► Loosen screw ( 7 ) SW3 and pull down the cover plate
( 8 ) to the rear.
► Block the motor gearbox with the locking knob ( 9 ).
Clamping fl ange ( 10 ) through opening hole of the
Unscrew the plates with an Allen key SW6
and clean. Remove the old saw blade.
► Make sure that the cutting and saw blades are centred
with the clamping nut (10).
► Insert the new saw blade and tighten with the clamping
fl ange.
► When inserting the cutting blade, pay attention to the
direction of rotation
► Slide cover plate back on and screw ( 7 )
tighten.
► Spare HM saw blade Ø 165mm 54 teeth #017227
4.0 Operation
4.1 Operating instructions
► Switch on picture B
Slide the switch rocker forward
and hold on. To switch off the rocker switch
release without engaging (short-term operation).
Push the switch rocker forward (1)
and by pressing the front end
engage (2) (continuous operation).
► Switch off Figure B
The switch is unlocked by pressing the switch at the
rear end (1). The machine switches off .
► Always hold and guide the door saw with both hands.
► Always operate the door saw on the fl oor,
Do not tilt or tilt the machine.
► Position the machine on the object to be sawn and
Advance the snowmobile to the set depth.
► Carry out the sawing process from left to right.
► When sawing doors, the door must always be held by a
second person. Otherwise vibrations of the door can be
transmitted to the machine.
4.2 Height adjustment Figure D
The height can be adjusted from 7 to 25 mm.
► Loosen the knurled screw ( 2 )
► Adjust the desired height by turning the toothed shaft
using the Allen key ( 3 ) SW5 supplied.
► The dimension can be read off the scale ( 4 ) on the
front side.
► Before starting work, check the height adjustment on a
test piece.
4.3 Depth adjustment Fig. C
The depth can be adjusted from 0 to 45 mm.
► Loosen the lever screw ( 5 ) of the depth stop.
► Set the desired depth by moving the depth stop ( 6 )
and retighten the lever screw ( 5 ).
► Before starting work, check the depth setting on a
specimen.
EN
19
Advertenties
Inhoudsopgave
