Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6. Battery pack and charging procedure
Charging
Charging
start
finish
Charging
Charging time*
standby
(not including standby time)
72
User manual English
TIP
Even if charging starts normally, charging might be suspended to
protect the battery if the battery temperature or ambient temperatu-
re becomes too high or too low. In this case, the battery may not
have sufficiently charged. Check the battery's residual capacity and
recharge if necessary.
6.6 Charging time guidelines
Although charging time varies depending on residual battery cap
city and external temperature, if the battery has been exhausted,
it generally takes approximately 4 hours until one battery capacity
indicator lamp flashes.
If the battery pack enters standby mode while charging, charging
time will increase by an equal amount.
* If charging after a long period of disuse, the charging time will be
lengthened depending on the battery status. However, note that if
the battery capacity indicator lamps do not flash in fault pattern
(see point 7.6 on page 60), there is no malfunction.
All manuals and user guides at all-guides.com
7. Checking the residual battery capacity
You can check the estimate of how much capacity is left in the battery and to what extent it is charged. The
check can be performed using either the display unit's residual battery capacity indicator or the battery's
residual battery capacity indicator lamps.
TIP
• Even if the battery's capacity reaches 0 (zero), you can still ride the bicycle as a regular bicycle.
• If you are using an old battery pack, the residual battery capacity indicator may suddenly display very
little power when you start moving. This is not a malfunction. Once riding stabilizes and the load is
reduced, the proper value is displayed.
7.1 Residual battery capacity indicator display and estimate of residual battery capacity
for display unit
The residual battery capacity can be displayed as a numeral value on the LCD display by using the function
select switch on the display unit to select this option.
Display of the residual
battery capacity on the
LCD display
Slow flashing
Ñ every 0.5 seconds Ò
Fast flashing
Ñ every 0.2 seconds Ò
Display of the
residual
Applicable situation
battery capacity
100 - 11%
When you turn on the power of the LCD
display and ride continually after the bat-
tery is fully charged, the segments for the
residual battery capacity indicator go out
one by one each time the residual
battery capacity is reduced by 10%.
10 - 1%
There is very little residual battery capacity
left. Please charge the battery soon.
0%
There is no more residual battery capacity.
Turn off the power, and charge the battery
pack soon. Assist is stopped, but you can
still ride the bicycle as a regular bicycle.
You can still use the light for about another
2 hours.
NL
EN
73
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
