Advertenties
Beschikbare talen
Beschikbare talen
SAFETY STANDARDS
AND
LOGO
In line with our policy of ongoing improvement,
we always aim to provide state-of-the-
art products compliant with current safety
standards. The rules and guidelines in this
document, therefore, reflect compliance
with the safety regulations and provisions
that apply. In addition to following the
recommendations in this document, all staff
potentially exposed to risks during the
installation, use or maintenance of our
equipment are strongly recommended to
ensure that it complies with the relevant
domestic safety regulations in force.
The CE marking and Declaration of conformity
provided attest to the compliance of our
products with the applicable Community
legislation.
However, SABIANA declines all liability
for personal injury or damage to property
caused by the failure to apply these safety
regulations or by unauthorised modification
of the product. When installation involves
other
products
the relevant certification rests with the
purchaser, who assumes full responsibility
for the certification of conformity of the
entire system.
The products are manufactured in
accordance with the following guidelines:
• Machinery directive 2006/42/EC
• Low Voltage Directive 2014/35/EU
• Electromagnetic compatibility
directive 2014/30/EU
• RoHS Directive 2011/65/EC
• Energy Related Products (ERP)
directive 2009/125/EC
without
CE
marking,
GENERAL INFORMATION
Please do not remove the safety devices.
However, if you need to remove a device (for
good reason), you should take immediate
measures to prevent possible hazards.
In addition, it is strongly recommended that
you reinstall the protective device removed
as soon as possible.
All (ordinary and extraordinary) maintenance
procedures must always be performed with
the product isolated from the power supply.
To minimise the risk of accidental starting
of a fan/motor during maintenance, it is
recommended that you place a suitable
warning sign on the control panels/control
boards, e.g. "Attention: Verify that the
power supply is disconnected before
performing any maintenance".
Also, before you connect a power cable to a
terminal block, check that the line voltage
corresponds to that indicated on the product
label. If the product labels become illegible
over time, please replace them.
WARNING!
All the internal wiring is located under the
top panel of the unit. For this reason, it is
not permitted to drill holes in the Panel.
To do so would involve a risk of electric
shock and damage to the unit. This also
applies to the control panel and the area of
the controls.
125
English
Advertenties
