Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Adding additional transmitters to the
3s
If installation data already exists for the transmitter being
programmed, the procedure will be terminated. Termination
is indicated by the red flashing of the LED ring. In this case,
the transmitter will need to be restored to factory settings.
28 - en
installation
Press the programming button on an already pro-
grammed transmitter for 3 seconds. The transmit-
ter performs a search and the LED ring continu-
ously changes colour. The transmitter then
switches to receiver selection and selects the re-
ceiver with the best connection quality.
▻ The receiver confirms.
Now press and hold the programming button for a
new transmitter.
▻ After 5 seconds, the LED rings on both
transmitters start to fill in green.
Continue pressing and holding the programming
button.
▻ Once the new transmitter has been ad-
ded successfully, both transmitters
flash green to confirm.
► The transmitter has been added success-
fully.
If the programming button remains pressed, it
starts a new search procedure and switches to the
receiver selection.
The programming process can be cancelled
at any time by pressing the STOP button on
the transmitter that has already been pro-
grammed or by releasing the programming
button.
Advertenties
Hoofdstukken
Inhoudsopgave
