Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
m
IMPORTANT!
During the firmware update the connection
u
status LED
flashes 5× per second . Do
[
12 ]
not disconnect the smart battery pack
from the cordless drill during the update
as the cordless drill will become unusable
if the update fails . During the update the
cordless drill becomes unresponsive to
input, e .g . triggering the on/off switch . The
update process takes around 5 minutes .
If the firmware update is successful, the
connection status LED flashes 1× per
second for 5 seconds . The cordless drill
becomes responsive to input again . You
can connect the battery pack to the
Lidl Home app following the chapter
"Connecting the product to the Lidl Home
app" .
˜ Reconnecting the cordless drill
m
IMPORTANT!
If the connection status LED
u
alternatively between 1× and 5×
per second, it means the connection
was disrupted . One of the reasons is
disconnecting the battery pack from the
cordless drill during firmware update . The
cordless drill will not be usable until you
re-established the connection it .
Proceed as follows to re-establish the connection
with the cordless drill:
1 . Attach the battery pack to the cordless drill .
2 . Press the on/off switch
status LED
flashes alternatively 1× or 5×
12 ]
[
per second .
3 . Enable Bluetooth on your mobile product .
4 . Press and hold the
level) on the smart battery pack for 3 seconds
to ensure that Bluetooth is activated on the
battery pack .
flashes
12 ]
[
. The connection
6 ]
[
button (charging
5 . Connect the battery pack to the Lidl Home
app following the chapter "Connecting the
product to the Lidl Home app" .
{Device
info}
6 . Select
under {Battery} . The overview page of the
cordless drill is displayed .
{Firmware
7 . Select
firmware .
8 . After successfully updating the firmware, the
connection with the cordless drill should be
re-established and the cordless ready for use .
˜ Reset to factory original
setting
{Reset}
Select
to restore the firmware to
o
original factory setting .
˜ Privacy policy
You can find the complete data protection
guideline under the tab
protection}{guideline} .
˜ Disconnecting the product and
deleting data from the app
1 . In the
tab, select the product that you
want to remove and whose data you want to
delete .
2 . Select the
icon in the top right .
{Remove
device} .
3 . Select
4 . To delete the data, select
delete
data} . If you just want to disconnect
the product without deleting the data, select
{Disconnect} .
˜ Problems with the app ‒ FAQ
1 . Select the battery pack you have questions
about from the product list .
2 . Select the
icon in the top right .
{Other}
3 . Under
select the option
(= frequently asked questions) .
"PABSP 20 Li C3"
version}
and update the
{Data
{Disconnect and
{FAQ}
GB/IE/NI
23
Advertenties
Hoofdstukken
Inhoudsopgave
