Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Hard screw joints (in metal)
Particularly high torque occurs, for example in
o
metal screw joints made using drive sockets .
Select a low rotational speed .
Soft screw joints (e.g. in soft wood)
Again, use a low rotational speed, e .g . to
o
avoid damaging the surface of the wood
upon contact with the screw head . Use a
countersink .
Drilling in wood, metal and other
materials
Use a high speed for drill bits with small
o
diameter and a low speed for drill bits with
large diameter .
Select a low speed for hard materials and a
o
high speed for soft materials .
Secure or fasten the workpiece in a clamp or
o
vice (if possible) .
Mark the spot where you want to drill using a
o
centre punch or nail . Select a low rotational
speed when starting .
Pull the rotating drill bit from the hole
o
repeatedly to remove dust and chips and
clear the hole .
Drilling in metal
Use a metal drill (HSS) . For optimum results,
o
cool the drill bit with cooling lubricant (cutting
oil) . Metal drill bits can also be used to drill
into plastics . Start with a 3 mm diameter drill
bit and then increase the size until the desired
hole diameter is achieved .
Drilling in wood
Use a wood drill with a lathe centre .
o
Deep holes: Use an auger bit .
Large-diameter holes: Use a Forstner bit .
Small screws can be screwed directly into soft
wood .
Belt clip (fig. J)
m
CAUTION! RISK OF INJURY!
Before hanging the product in the belt:
u
Push the rotation direction switch
the centre position (lock) . This prevents
the product from being switched on
accidentally .
The belt clip
allows the power tool to be
[
9 ]
o
hooked on belt or pocket .
˜ Activate/deactivate the
Bluetooth function on the
battery pack
NOTE
The Bluetooth function is only available for
u
Parkside smart batteries PAPS 204 A1 and
PAPS 208 A1 . The included battery pack
PAP 20 B1 does not feature the Bluetooth
function .
Press and hold the
o
pack for 3 seconds to activate the Bluetooth
function . The yellow charging level LED lights
up . The Bluetooth function is enabled .
Release the
button .
o
Press and hold the
o
battery pack for 10 seconds to deactivate
the Bluetooth function . The yellow charging
level LED goes off . The Bluetooth function
is deactivated . In the Lidl Home app the
battery pack is shown as offline .
˜ Connecting the product to the
Lidl Home App
NOTE
The product can only be connected to the
u
Lidl Home app if the battery pack is
inserted in the product .
Only Smart Performance rechargeable
u
batteries can be connected to the Lidl
Home app .
to
5 ]
[
button on the battery
button on the
GB/IE/NI
19
Advertenties
Hoofdstukken
Inhoudsopgave
